Leading Surge Protection Device Manufacturers | BENY New Energy

A surge protective device (SPD) chosen from an inverter's usual operating voltage can miss the array's cold-weather maximum. For typical photovoltaic (PV) modules, open-circuit voltage—the voltage with no load drawing power—rises as the cells cool. A midday operating reading is therefore not the design maximum; selection needs the designer's cold-weather calculation.

The task is to connect the array voltage assessment with the exact SPD's application limits. It is not to add an arbitrary margin to a familiar catalogue number or assume that a larger voltage label is automatically a better protective choice.

Obtain the actual maximum-voltage calculation

Use the selected module's voltage temperature coefficient, the number of modules in series and the site's design minimum temperature. These are inputs to the maximum-voltage calculation, not values to copy from a neighboring roof. Keep them with the designer's calculation and the module documents.

A hypothetical procurement file that lists only module power and inverter capacity is incomplete for this purpose. Request the controlled maximum-voltage calculation and its input documents. Record the module identity, modules in series and temperature basis through that design reference, rather than rebuilding the calculation from an unrelated example found online.

Keep different voltage quantities separate

The module's reference open-circuit value, the string's calculated maximum voltage and its normal operating voltage answer different questions. Label them clearly in the selection record. Comparing an SPD with the wrong quantity can make an apparently comfortable voltage margin meaningless.

Keep two entries on the review sheet: the maximum continuous operating voltage stated for the SPD, and its surge-protection performance rating. They are different ratings. UL's industrial-panel selection guidance lists both among the factors to check; it does not supply a PV sizing rule. Use the PV model's own instructions and the project design to evaluate them.

Select a documented configuration

Use the complete SPD model and its intended direct-current (DC) application. Confirm the circuit arrangement and any conditions attached to the manufacturer's ratings. The selection must also fit the project's protection strategy and installation requirements; a voltage comparison is one part of that decision.

Send the supplier the calculated maximum PV voltage and system arrangement with a named candidate from the BENY PV surge-protection range. The page lists Type 2 and Type 1+2 models, but their applicable ratings belong to the individual product documents. The designer must compare those documents with the cold-weather calculation before acceptance.

Revisit the check when strings change

An inverter replacement or module retrofit can alter string configuration while leaving an existing SPD in place. Compare the new design inputs with the previous selection record. A retained operating current or familiar enclosure does not establish that the voltage assessment is unchanged.

If the retrofit also adds storage, identify the PV circuit and battery connection separately. A PV-device label does not establish suitability for a battery bus; require application evidence for the actual connection. Keep that question separate from the cold-weather PV voltage check.

Carry the decision into handover

The equipment schedule should connect the chosen SPD to the relevant voltage-calculation revision, model documents and circuit tag. Keep assumptions and unresolved items visible until the responsible designer has accepted the selection. Do not label an unverified number as a measured site maximum.

The resulting record is useful long after the first winter. A future change can be checked against the original module, temperature and string assumptions without guessing why the SPD was chosen. Cold-weather review then becomes a traceable design input, rather than a warning added after procurement has already fixed the equipment.